FITTING: The Naked Brass conductor must be 13mm

·        Insert universal receptacle (rear side leading) into the front opening of the mounting frame.

·        Press receptacle into mounting frame until it snaps and securely locked-in with the mounting frame

·        Snap on the face plate if applicable

·        Insert the stripped wire into the wire insertion openings on the back of the universal receptacle

·        The gauge of the wire must be 13 mm to ensure a secured clamping contact once inserted

·         To remove the wire, press down the wire release button next to the insertion opening and remove

·        To remove the receptacle, insert a screw driver into the notch between the mounting frame and the receptacle

·        Turn the screw driver clockwise or counter-clockwise to push away the locking clamp on the mounting frame from the receptacle

·        At the same time, use you thumb to slightly push the operation side of receptacle down to release it from the mounting frame

·        Apply the same sequence on the other side to release the receptacle from the mounting frame

·        Gentle push the receptacle from its back to detach it from the mounting frame